top of page

Arctic Cat F7 / M7 to F8 / M8 Big Bore Kit

From

Price

$2,118.00

The RK Tek Arctic Cat F7/M7 to F8/M8 Big Bore Kit is designed to convert the Arctic Cat 700cc lay-down engine into a high-performance 800cc configuration. The package combines cylinder boring and replating, custom porting, RK Tek pistons, OEM head modification, and exhaust-valve components to create a complete big-bore conversion.

The kit is designed to provide substantial horsepower and torque gains while retaining the ability to run on 91-octane pump gas. With the stock exhaust system, the engine can also be operated using the stock fuel mapping without an aftermarket EFI controller.

Application & Performance

  • Converts the Arctic Cat 700cc lay-down engine to approximately 800cc

  • Custom cylinder porting designed specifically for the big-bore configuration

  • OEM cylinder head is reshaped to RK Tek's combustion-chamber design

  • Designed to run on 91-octane pump gas

  • No airbox modifications required

  • Operating RPM range of approximately 8,000–8,250 RPM

  • Multiple exhaust configurations can be used depending on the desired performance level

Performance by Exhaust Configuration

  • Stock pipe and silencer: approximately 160+ HP

  • Aftermarket single pipe: approximately 170+ HP with increased low-end torque

  • Twin pipes: approximately 180+ HP, with some reduction in low-end performance between approximately 4,000–5,500 RPM

Fuel Controller Requirements

With the stock pipe and stock silencer, the kit is designed to operate using the factory fuel mapping and does not require an aftermarket EFI controller.

An aftermarket fuel controller is required when using aftermarket pipes or silencers.

Kit Includes

  • Cylinder boring and replating

  • Custom cylinder porting

  • Two 85mm pistons

  • OEM head rechambering

  • Two exhaust-valve spacers

Important Information

This is a conversion service that requires the customer's OEM cylinders, cylinder head, and exhaust valves to be sent to RK Tek for modification.

Before sending the cylinders, remove the exhaust-flange studs and cylinder-locating dowels. RK Tek also requests that cylinders and exhaust ducts be thoroughly cleaned before shipment.

Only the exhaust valves themselves need to be sent—do not send the cables or servo housings. 

Available Options

  • Caged Wrist Pin Bearings — +$80

  • Top End Gasket Kit — +$90 

Caged Wrist Pin Bearings (2)

Snowmobile Make

Model

Year

Fuel Octane (optional)

Altitude (optional)

Quantity

bottom of page